MobileDimmer
2-Wire RF Dimmer
The dimmer can be branched in the same way as a switch. It is not necessary to replace the existing installation. The dimmer is suitable for incandescent lamps and halogen lamps with an electric potential of 12 or 24V. The built in soft-start feature provides a longer lamp life.
Once the dimmer is turned off the dimmer only consumes 1 mA, which is significantly lower than the self-discharge of the onboard battery. The dimmer can be controlled by the switch as well as by the remote control. The light is switched on and off by briefly pressing the switch. The light intensity can be adjusted by pressing the switch for a longer period of time. Once the dimmer is turned off the last established light intensity is retained.
- Remote control using RF technology
- High power 60W@12V / 120W@24V
- Auto input voltage detection 12 or 24V
- Power supply limit 8 – 30 V DC
- No extra wires to install
- Controlled by microprocessor
- Built in soft-start feature for longer bulb life
- Built in thermal fuse 10 A (no self-reset)
Mobiledimmer Remote
This RF remote control enables you to control up to 16 dimmers.
By means of a straightforward batch control option all dimmers
can be switched on or off at once. After switching the lights off the last settings are retained. When switched back on, the lights are restored to their last state. Through a simple key control you can add up to 16 dimmers to your remote.
- 16 channels per remote
- adjustable code system (256 codes)
- transmitter frequency : 433.92 MHz
- transmission range : 30 metres (102 ft)
- Includes a 3 Volt lithium battery (type CR2032)
New developments
CAN BUS
Currently there is an ongoing research within our R&D department into the CAN-bus technology and its applications within the maritime sector. Examples of such products include:
- tank level senders
- motor management system readouts
- various types of display and control products
Future areas of interest also include compliance with the NMEA2000 standard.
ULTRASONIC DISTANCE MEASUREMENT
Research is currently being done to determine the feasibility of using ultrasonic distance measurement techniques in combination with a smart software filtering solution for fluid level sensing applications. By adding a CAN-bus interface to such a sensor, it becomes possible to show several fluid levels on a display and to initiate the appropriate action when one or more levels become critically low/high.2-WIRE DIMMER SWITCH
- Easy to instal, just replace te switch
- No extra wires to instal
- Auto input voltage detection 12 / 24V
- Built-in softstart for longer bulb life
- High efficiency by using switch mode techniques
- High power 60W@12V / 120W@24V
- Microcontrol controlled
Introduction:
The dimmer is intended for building in. The 2-wire dimmer is suitable for light bulbs and halogen light-ing; 12 or 24 V direct current.
‘Softstart’ ensures a long lifetime for the lights. The light is off when the dimmer is set to ‘fully dimmed’ and the current taken by the dimmer is then only about 1 mA. (This is significantly less than the self-discharge of the battery.)
Installing:
The dimmer can be connected in the same way as a switch and can there-fore replace the switch in an existing instal-lation. The dimmer can be fitted in both the plus and the minus wire.A build-in box can be used if required (make: Berker, type B.MOBIL).If the dimmer is connected wrongly the light will be on continuously.
Operating:
Press briefly:lighting is switched on with the most recently set light strength or switched off.
Press for a longer time:to adjust the light strength.
Technical details:
- Power supply : 12 Volt or 24 Volt direct current
- Power supply limits : 8 to 30 Volt
- Maximum loading : 60W@12V / 120W@24V
- Safety protection : built-in thermal fuse 10 A (not self-resetting)